Vcarve 3D mini project issue

[tankerzuke]

So I was doing some of the training that comes with Vcarve and found an error. I was watching the 3D mini-project with the wine sign that says vintages. At the end of the first video it says there is another that shows you the steps for the text but when you click on that video it is the same video as the one just watched. How do we let them know and can anyone tell me where I might find the correct video? Thanks

Zuke

[highpockets]

Try this one.

http://support.vectric.com/tutorials/V9 ... &time=1624
and this one for creating the toolpath for the text.
http://support.vectric.com/tips-and-tri ... ideo_id=11

[martin54]

If you need to contact Vectric about anything then best to just send an email, same email for address for things like problems, feature requests, software errors etc etc

support@vectric.com

[tankerzuke]

Try this one.

http://support.vectric.com/tutorials/V9 ... &time=1624
and this one for creating the toolpath for the text.
http://support.vectric.com/tips-and-tri ... ideo_id=11

Hey Highpockets, the first one is the video I was referring to in my original post that just repeated itself lol

[Adrian]

When I checked this morning the link was correct. Where did you see it incorrect? You were clicking on the related video link at the bottom of the page not the actual video itself?

[martin54]

OK think I know what you did, after reading Adrians post I went to look myself, at the bottom of the page where the related links are there are a couple of things that have links, one says cnc mini project the other is a picture of the project. One leads you back to the tutorial you just watched the other to a different tutorial. The into for both looks exactly the same so let it run for a few seconds