Material setup

This forum is for general discussion regarding VCarve Pro
Post Reply
paul60
Vectric Craftsman
Posts: 119
Joined: Fri Sep 10, 2010 8:29 pm

Material setup

Post by paul60 »

I need to set up rapid z gap above material
it look like it has a default setting of 0.2
i need to set this to .5 . but when i do and i restart vcarve it goes back to 0.2
i need it to remain at .5 until i need to change to another number
Thanks

User avatar
Adrian
Vectric Archimage
Posts: 14543
Joined: Thu Nov 23, 2006 2:19 pm
Model of CNC Machine: ShopBot PRS Alpha 96x48
Location: Surrey, UK

Re: Material setup

Post by Adrian »

It's a setting that stays at the last used value or what is set in the file. So if you load a file it will be whatever that file was saved with. If you start a new job then it will be whatever the last setting was set at.

Those settings do work with each other so the Rapid Z and Gap Above Material will all change to sensible values if what you enter doesn't make sense.

paul60
Vectric Craftsman
Posts: 119
Joined: Fri Sep 10, 2010 8:29 pm

Re: Material setup

Post by paul60 »

Thanks adrian got it

Post Reply