No apology necessary. It will never happen that the software won't allow a particular size to be entered. Never.sharkcutup wrote:OOPs! My Bad!!!
I have not needed a 3/16" .(.1875) router bit so never really shopped for one. I was just trying to make a point that if there is not a certain size shouldn't the software NOT allow it. But in this case (again My Bad) the software would allow it because there are that size bits available.
My Apologies everyone!!!
Sharkcutup
Bit diameters can vary from their advertised size, custom bits are made, dimensions of a bit diameter changes after sharpening and on and on. The user must be able to input any diameter they need.