We have an order for 50,000 plastic tags that are all sequentially numbered. I am the Graphic Designer and need to set up the artwork to be carved. I downloaded a stick font that I can use in InDesign because it's easy to do the sequential numbering in that program. When we open the file in VCarve, the router ends up tracing each letter and number twice. It takes an entire day if not longer to do 200 tags. At this rate we'll never get the job done! I need a font that will only be traced once and that is compatible with InDesign. I've searched everywhere and these fonts are so hard to find. If this is not possible, is there any other way to do the sequential numbering in another program that would work in VCarve? Or is it possible replace fonts with the VCarve fonts when you open it in there?
Thanks in advance!