Mikehell wrote:I have some .5mm bits and smaller. The software will accept them, but good luck cutting anything with a .5mm bit without it snapping in half.
I want to try stock checkering.
martin54 wrote:Mikehell wrote:I have some .5mm bits and smaller. The software will accept them, but good luck cutting anything with a .5mm bit without it snapping in half.
I have bits smaller than that & a lot is down to the quality of the bits, the settings used & how rigid your machine is. I have snapped them but usually because I was trying to push them to hard.
What I tend to use the most though if I am using small bits are tapered ball nose bits, have them down to 0.5mm & you can get away with a lot more than you would using a straight shank bit of the same size
martin54 wrote:I haven't come across tapered bits that come to a true point only ball nose. The engraving bits I have that come to a point came with the machine & are either 6mm or 1/4" shank.
I thought that checkering had a flat bottom which was why I had suggested using an engraving bit with a flat tip, Mike-S who has a lot more experience than me put me right on that one
As I have said before I am probably way to conservative with my feed settings which is maybe why I haven't broken the tips off more bits but the machine plays a big part as well, especially with small bits, when was the last time you checked the run out on your spindle ? Even with a rigid machine to much run out will break bits
anyducks wrote:I want to try stock checkering.
Users browsing this forum: No registered users and 30 guests