I have not been able to devote much time to my cnc lately. I did upgrade to vcarve 9.
I setup a job and noticed my gantry moved the wrong direction. So I figured Ah HA, I must have set the datum wrong. I went back to vcarve and checked, it was at top left (where I usually put it). but the orientation of the datum was now different then on older projects. Am I going nuts? Did some change happen in the software?
How can rotate the datum?
datum orientation
-
- Posts: 47
- Joined: Mon Nov 30, 2015 9:54 pm
- Model of CNC Machine: Shapeoko
- Location: Schaumnurg, Illinois
Re: datum orientation
Never mind. I'm an idiot. Been away to long. Operator trouble here.
-
- Vectric Wizard
- Posts: 414
- Joined: Wed Apr 01, 2009 12:15 am
- Location: Dunnellon, Florida
Re: datum orientation
I hate that when it happens. Your not the first nor will you be the last.