Bit Can't Fit

[gkas]

I imported the truck body from a pdf. Sizes come in accurate. My problem appears when I try to cut the profile for the body.

No problem with most of the toolpaths, until I set up the profile to cut out the body. Cut with a 0.25 EM to Outside. I get the message "ERROR No toolpath generated for current parameters. Check tool can fit into selected vectors at machining depth." I change to a 0.125 bit... same problem. Both the 0.25 and the 0.125 will cut if I set the Machine Vectors to ON. It's gotta be something stupid....

Truck Cab_1.crv

(181 KiB) Downloaded 83 times

[highpockets]

It's not a closed vector, look at the nose of the truck where the hood comes to a point.
Use "Join/Close vectors with a straight line"

[gkas]

Thanks much... That did it. Since it came from a pdf, I should have looked for open vectors. I gotta add that to my "list of things to check when weird mistakes pop up".

[highpockets]

Add the Vector Validator to that list, it wouldn't have help in this case, but with imported vectors it really helps.