Angled Lines starting from the same point

This forum is for general discussion regarding VCarve Pro

Angled Lines starting from the same point

Postby jib2 » Mon Oct 15, 2018 4:11 pm

Maybe I just can not figure this out it seems simple but it needs to be real accurate. So, some help would certainly be appreciated for sure.

Ok, here goes

Would like to draw a series of line at specific angles all starting from the same point. I.E. board say 6" wide by 12" tall starting point to connect all the line at the lower left corner one inch above the board edge. At these degrees: 5, 10, 15, 20, 25, 30, 35, 40, 45, 50

I know how to draw a line and use the "Rotate Selected Objects Tool" tool to rotate each line but can not figure out how to anchor all of them to the same point in the lower left hand corner.

So, what am I messing.

Thanks for any help you can provide.
jib2
Vectric Apprentice
 
Posts: 62
Joined: Mon Nov 03, 2014 12:46 am
Model of CNC Machine: Laguna CNC

Re: Angled Lines starting from the same point

Postby LittleGreyMan » Mon Oct 15, 2018 4:26 pm

If this feature is available in Vcarve, use "Create a circular array of copies" in the "Offset and Layout" button group.
Last edited by LittleGreyMan on Mon Oct 15, 2018 4:29 pm, edited 1 time in total.
Best regards

Didier

W7 - Aspire 8.517
LittleGreyMan
Vectric Apprentice
 
Posts: 918
Joined: Fri May 15, 2015 1:10 pm
Location: France
Model of CNC Machine: 3 axis small size machine

Re: Angled Lines starting from the same point

Postby Adrian » Mon Oct 15, 2018 4:27 pm

It is. VCarve has all the 2D tools that Aspire has.
User avatar
Adrian
Vectric Archimage
 
Posts: 9595
Joined: Thu Nov 23, 2006 2:19 pm
Location: Surrey, UK
Model of CNC Machine: ShopBot PRS Alpha 96x48

Re: Angled Lines starting from the same point

Postby jib2 » Mon Oct 15, 2018 5:00 pm

Thanks so much works like a charm. Much appreciated
jib2
Vectric Apprentice
 
Posts: 62
Joined: Mon Nov 03, 2014 12:46 am
Model of CNC Machine: Laguna CNC


Return to VCarve - General

Who is online

Users browsing this forum: Google [Bot] and 24 guests