Hello everyone, thanks to this forum I've been able to get a file cut on my schools shopbot. I was looking to optimize the file and find the proper bits to use. Right now I'm using a 1/2" 48-072 for all the 1/2" cuts, and a generic upcut 1/8 bit I found for all the 1/8" cuts. What are the proper bits and depths needed for this type of toolpath? I can't describe the actions very well, I hope the file below can clear everything up.
For reference, I'm planning to use hardwoods like Walnut, purple heart, and cherry for most of my tests.
Thanks!
Proper Bits and depth Cuts
Proper Bits and depth Cuts
- Attachments
-
- Split_bluetooth_School.crv
- (268 KiB) Downloaded 163 times