Need some help with a 3D model

This forum is for general discussion regarding VCarve Pro

Need some help with a 3D model

Postby KennesawGA » Sat Oct 28, 2017 4:56 pm

I downloaded the STL file to make a sphere using a 3 axis CNC. It breaks a sphere into 4 parts that can be cut with a 3 axis machine and then assembled into a sphere. The attached picture shows the render after the finish pass is done and a profile cut around each piece through the material. The finish pass is setup to cut to the edge of the material to better show what it is doing in the picture.

I have tried changing the model position in the material and it has not helped.

My problem is that for some reason only the top half of the model is being cut.

My material is 1.5 inches thick.

When I imported the model, I scaled the model to be 1.49 inches in Z (with X and Y scaling to Z). I centered the model in my material and made sure the model was completely contained in the material.

I have made many 3D bas Reliefs from STL files and I have never encountered this problem before. Obviously I am doing something wrong, but I just cannot figure out what it is.

Any help would be greatly appreciated!
sphere vcarve.JPG
Screen shot of model rendered in Vcarve
Attachments
hemidemi-stl.zip
STL model I am trying to carve
(736.32 KiB) Downloaded 20 times
KennesawGA
 
Posts: 7
Joined: Fri Jul 03, 2015 6:33 pm
Model of CNC Machine: X-Carve 500x500

Re: Need some help with a 3D model

Postby garylmast » Sat Oct 28, 2017 10:25 pm

Add a zero limit plane and offset the boundary the radius of the mill.
Attachments
Capture.JPG
garylmast
Vectric Wizard
 
Posts: 569
Joined: Fri Oct 23, 2009 4:03 pm
Location: Sandy, Utah

Re: Need some help with a 3D model

Postby Mike-S » Sat Nov 04, 2017 4:41 pm

When you imported the .stl did you set the Zero Plane Position to "Bottom"? Looks like yours was set for "Middle."
Attachments
hemdem.jpg
User avatar
Mike-S
Vectric Wizard
 
Posts: 953
Joined: Mon Jun 13, 2011 6:45 am
Location: Hayesville, NC
Model of CNC Machine: Joe's Hybrid 4x4 (but 3x3)


Return to VCarve - General

Who is online

Users browsing this forum: Barry Anderson, jib2 and 19 guests