4DThinker wrote:If you choose the raster option with your pocket toolpath you can set it to do a profile pass as the last pass. This will do exactly what has been suggested previously, but all in the same toolpath.
I only use an allowance on pockets for joinery that has two parts that need to fit precisely. So yes, with the raster option and last-pass profile I don't use an allowance. I also try and set the raster direction to run parallel with the wood grain.RobH063 wrote:4DThinker, if using the Raster option, would you eliminate the pocket allowance because there would be no need to do a finish pass?
Users browsing this forum: No registered users and 11 guests