V carve pro ingaving picture
V carve pro ingaving picture
need help ,, did i miss something. ingraving a picture once started i found out my picture was being carved flipped horizontaly from original,,
- FixitMike
- Vectric Wizard
- Posts: 2177
- Joined: Sun Apr 17, 2011 5:21 am
- Model of CNC Machine: Shark Pro Plus (retired)
- Location: Burien, WA USA
Re: V carve pro ingaving picture
This can happen if you have swapped the X and Y axis drive cables on the Shark controller.
Good judgement comes from experience.
Experience comes from bad judgement.
Experience comes from bad judgement.
- FixitMike
- Vectric Wizard
- Posts: 2177
- Joined: Sun Apr 17, 2011 5:21 am
- Model of CNC Machine: Shark Pro Plus (retired)
- Location: Burien, WA USA
Re: V carve pro ingaving picture
Some additional notes and questions:
1. For others: FYI the Shark controller and control panel are nothing like Mach3.
2. If the VCarve preview is correct, it is not a VCarve problem. It is a machine control problem.
3. Is it only this job that is reversed? If so, it doesn't really make sense.
4. What changes in your machine have you made recently?
5. What happens when you jog Y ? Your gantry (bridge) should move. If something else moves, the drive motor cables are plugged into the wrong sockets.
1. For others: FYI the Shark controller and control panel are nothing like Mach3.
2. If the VCarve preview is correct, it is not a VCarve problem. It is a machine control problem.
3. Is it only this job that is reversed? If so, it doesn't really make sense.
4. What changes in your machine have you made recently?
5. What happens when you jog Y ? Your gantry (bridge) should move. If something else moves, the drive motor cables are plugged into the wrong sockets.
Good judgement comes from experience.
Experience comes from bad judgement.
Experience comes from bad judgement.
Re: V carve pro ingaving picture
checked all cables. everything is ok, It's no big deal for now. but i will have to check for the next project. Nothing as been touched after all the ajustements have been done, so i'm realy bugged