ruler settings

This forum is for general discussion regarding VCarve Pro
Post Reply
Steve Misher
Vectric Apprentice
Posts: 88
Joined: Thu Feb 02, 2017 2:40 am
Model of CNC Machine: Axiom AR4
Location: Wisconsin

ruler settings

Post by Steve Misher »

Is there a way to change the ruler settings on the top and left of the drawing tablet, from tenths to actual inches?

markevans36301
Posts: 46
Joined: Sun Feb 23, 2014 9:09 am
Model of CNC Machine: shopbot handibot

Re: ruler settings

Post by markevans36301 »

I'm not in front of my computer right now but I believe these Auto scale depending on how far zoomed in you are.

Steve Misher
Vectric Apprentice
Posts: 88
Joined: Thu Feb 02, 2017 2:40 am
Model of CNC Machine: Axiom AR4
Location: Wisconsin

Re: ruler settings

Post by Steve Misher »

Even when you zoom in, it still is in tenths of a inch. I would like it to be in 1/32, 1/16,1/8,1/4 etc.

User avatar
Adrian
Vectric Archimage
Posts: 14544
Joined: Thu Nov 23, 2006 2:19 pm
Model of CNC Machine: ShopBot PRS Alpha 96x48
Location: Surrey, UK

Re: ruler settings

Post by Adrian »

The software works in decimals not fractions so the ruler is always in tenths.

Steve Misher
Vectric Apprentice
Posts: 88
Joined: Thu Feb 02, 2017 2:40 am
Model of CNC Machine: Axiom AR4
Location: Wisconsin

Re: ruler settings

Post by Steve Misher »

Thanks Adrian
I wasn't sure, but it makes sense, I was just wondering if it was possible.

Post Reply