stone engraving.

Post by **EugeneJohn** » Sat Nov 10, 2007 7:46 pm

Can anyone help me with the speeds and feeds that are needed for engraving letters in sandstone?
I am going to use a 1/2 inch 90 deg bit.
Regards to all,
Eugene John.

Post by **Tony Mac** » Sat Nov 10, 2007 8:07 pm

Hi Eugene,

There's some information on engraving memorials into marble and sandstone in this thread,

http://vectric.com/forum/viewtopic.php?p=259#259

http://vectric.com/forum/viewtopic.php?p=2982#2982

I hope this helps,

Tony

Post by **EugeneJohn** » Sun Nov 11, 2007 9:25 pm

Thank you Tony Mac, the downloads were very helpful at least I know that sandstone engraving is possible.
Eugene.