AXYZ Millenium with Toolpath

This forum is for general discussion regarding VCarve Pro

AXYZ Millenium with Toolpath

Postby thielee » Thu Oct 15, 2015 12:21 am

Hi everyone,
I recently upgraded to Vectric VCarve 8.0 to design products that our AXYZ Millennium could carve/cut out. I am using an older version of Toolpath controller software (last updated in 2008). When I open the Vectric .nc file in toolpath, it highlights lines as if its going to cut to the outside (or inside) of them, rather than do a centerline cut. On top of that, if I chose to have it "Engrave 3D" like we used to in the past, a lot of the image gets lost in the translation. Does anyoun out there have experience with AXYZ's and Toolpath with Vectric? Any help you could give me would be much appreciated. I teach woodworking at the local high school and have many kids eager to use/carve their projects. Thanks again.
Vectric Apprentice
Posts: 1
Joined: Thu Oct 01, 2015 6:22 pm
Model of CNC Machine: AXYZ Millenium

Return to VCarve - General

Who is online

Users browsing this forum: JBJeppson, pbb116 and 21 guests