I wanted to report a couple of minor things I've noticed with the software that I thought you would be interested in.
1. I created a toolpath. I wasn't satisfied with the depth or feed rate so I went back into the toolpath to make changes. From inside the toolpath edit, I went into the tool database and changed the feed rate as well as the pass depth for my tool. I then re-calculated the toolpath. When I re-ran the tool-path, it apparently did not pick up the change in feed speed or pass depth.
2. In the toolpath list box, I am assuming the arrow buttons to the right of the box should take you to either the top of the list - or the bottom. I've noticed that the down arrow does not appear to be working.
Is there are limit as to the number of toolpaths I can define in a file?