hi anyone working with a biesse rover b 4.65ft, i`m trying to run some programs with the vcarve pro but the machine always go to the same point. I already checked the tips from other post, but is not working for me. I set mm the measure and ran the biesse rover arcs mm
Thanks for your help
biesse rover b 4.65ft post processor
Re: biesse rover b 4.65ft post processor
Did you get your Rover to run? Using Vectric? I just purchased an older Bessie rover b.4 and am struggling to get the post up and running. would you be willing to share your p_p and any tips you might have
- Rcnewcomb
- Vectric Archimage
- Posts: 5887
- Joined: Fri Nov 04, 2005 5:54 am
- Model of CNC Machine: 24x36 GCnC/WinCNC with ATC
- Location: San Jose, California, USA
- Contact:
Re: biesse rover b 4.65ft post processor
I doubt you will get a response since that user (rover b) hasn't been on the site since 2013.
Code: Select all
Last visited:Mon Dec 02, 2013 10:49 am
- Randall Newcomb
10 fingers in, 10 fingers out, another good day in the shop
10 fingers in, 10 fingers out, another good day in the shop