Sent this to Tony and Brian, but since it's late in jolly old England and curosity is getting the best of me, I wanted to post this and see if a) others get the same results or b) if any one can point out a difference in way I setup my 3.1 and 4.0 versions to explain why my 4.0 toolpath seems to show many more jog moves and longer run time than 3.1
I created the file in 4.0 and noticed a lot of jog moves in the vbit toolpath, so I exported as eps and brought into 3.1 and tried to re-create with exact same tools an parameters. Maybe I've done something different in 3.1 and 4.0 with tool setup or something, but I'm overlooking it if so.
Thanks!
4.0 question
4.0 question
- Attachments
-
- banshee_31.crv
- 3.1 crv file
- (1.3 MiB) Downloaded 156 times
-
- banshee_40.crv
- 4.0 crv file
- (1.37 MiB) Downloaded 162 times
Re: 4.0 question
Try and import the same eps that you imported in 3.1 back into 4 and I am sure you will see a difference. Import the exact same file not one that looks like it.kzeyus wrote:and brought into 3.1 and tried to re-create with exact same tools an parameters.
Thanks!
Re: 4.0 question
Hi kzeyus,kzeyus wrote: so I exported as eps and brought into 3.1 and tried to re-create with exact same tools an parameters.
I was talking about the eps you exported from Vcarve 4 and imported into 3.1. Vcarve 4 may have cleaned it up during the export so it looked better in 3.1 Hope you didn't take offence in my explanation.