Difficult to explain.
Example: I have 3 pieces approximately .75 + - .05, each different, clamped to my machine .
I want to pocket them so I have all three exactly .65 remaining.
How do I do that?
Marv
Pocket to fixed remaining amount
-
- Vectric Wizard
- Posts: 1687
- Joined: Sun Oct 24, 2010 7:28 pm
- Model of CNC Machine: homebuilt 4'x2' (Mach3+G540)
- Location: Guelph, Ontario
- Contact:
Re: Pocket to fixed remaining amount
1) reference Z=0 to the table, not the material top, tell VCP where Z=0 is in material setup
2) tell VCP your material is 0.8" thick for each piece
3) make a pocket that is 0.15" deep in each piece.
Cheers!
2) tell VCP your material is 0.8" thick for each piece
3) make a pocket that is 0.15" deep in each piece.
Cheers!
Paul Rowntree
WarpDriver, StandingWave, Topo and gadgets available at PaulRowntree.weebly.com
WarpDriver, StandingWave, Topo and gadgets available at PaulRowntree.weebly.com
Re: Pocket to fixed remaining amount
That works perfect! Thank you
Marv
Marv