Wall Hanging needing help

[WoodChucksCNC]

OK here is a wall hanging that I am making for my dad. I have been patiently waiting for Aspire 4 to do a basket weave in the corners since I enjoyed Vectric in Ohio.
Now that it has been pushed back I am asking if someone that is lucky enough to have the beta could whip out a nice basket weave for me 40"x40" with about 1/2" weaves I would greatly appreciate it.

If you have any comments or suggestions on the design, I will welcome them. I did not make the models but I did modify two different ones and then put them together.

The hanging will be approx. 40"x40"x1.5" made from honduras mahogany.

Thanks for any help

[Ms Wolffie]

Carveone has made some nice basket weaves for the Paradise Box, check the thread "A different spin on the Paradise Box".
http://www.vectric.com/forum/viewtopic.php?f=5&t=14128

Cheers
Wolffie

[tmerrill]

As much as we would like to help, doing something like that with the beta version would not be proper.

Creating a weave pattern with the current version is not that hard and there have been numerous posts about it with most including .crv3d files you can download and use. Here are a couple:

http://www.vectric.com/forum/viewtopic. ... ve&start=0

http://www.vectric.com/forum/viewtopic.php?f=27&t=12374

Tim

[WoodChucksCNC]

OK Tim,
Not sure why that would not be proper. I have tried making what I wanted but did not succeed. I will look at the threads you have refered.

Thanks

[esteeme1]

WoodChuck,

I did this weave quite some time ago as an example. It was done in 3.5. you can cut and past is to fill the area you need it to and cut the excess.