1013 IntelliCarve Post Processor
1013 IntelliCarve Post Processor
Is there a post processor for the Oliver 1013 IntelliCarve.
-
- Vectric Wizard
- Posts: 4797
- Joined: Thu May 18, 2006 3:24 pm
- Model of CNC Machine: ShopBot
- Location: North Carolina
Re: 1013 IntelliCarve Post Processor
They don't have a very good website, but if you follow their specsheet instructions you will need to contact them.
Good Luck.
Tim
Good Luck.
Tim
Re: 1013 IntelliCarve Post Processor
Tim,
Thanks, I sent them an e-mail.
Thanks, I sent them an e-mail.
- rhds1
- Posts: 4
- Joined: Wed Aug 22, 2012 7:48 pm
- Model of CNC Machine: Oliver 1013 Intellicarve
- Location: Southern Missouri, USA
Re: 1013 IntelliCarve Post Processor
This is old news likely, but I talked to the Tech Support Rep today. He said he did
have a post processor and would send it to me via email. However he was at a
manufacturing show in Atlanta until next week. He gave me his email address
in order to send my request so when he got back it would tickle his memory.
Like I said likely this is all settled, but I just ran across this thread so added my
two cents. Rick
have a post processor and would send it to me via email. However he was at a
manufacturing show in Atlanta until next week. He gave me his email address
in order to send my request so when he got back it would tickle his memory.
Like I said likely this is all settled, but I just ran across this thread so added my
two cents. Rick