Tray carving

This forum is for general discussion regarding VCarve Pro

Postby MZiegler » Wed Feb 07, 2007 9:44 pm

It also possible to cut slant sides on the outside of the tray too. There a preview image of that. Basically the same method as doing the 3D stars I wrote about in a different thread. Mark
Attachments
slant bowl.jpg
MZiegler
Vectric Apprentice
 
Posts: 51
Joined: Mon Feb 20, 2006 3:06 pm

Postby MZiegler » Wed Feb 07, 2007 9:47 pm

Here is the crv file. Just select the preview all toolpath button, it will run the toolpaths in the right order. Mark
Attachments
VCarve Tray outside slant.crv
(51.5 KiB) Downloaded 136 times
Last edited by MZiegler on Wed Feb 07, 2007 9:55 pm, edited 1 time in total.
MZiegler
Vectric Apprentice
 
Posts: 51
Joined: Mon Feb 20, 2006 3:06 pm

Postby MZiegler » Wed Feb 07, 2007 9:49 pm

With a little more work to this file (by placing a couple tabs on the tray and placing two location pins in the waste area) you could cut the inside and then the flip the tray over to cut the outside. Mark
MZiegler
Vectric Apprentice
 
Posts: 51
Joined: Mon Feb 20, 2006 3:06 pm

Postby Bob Reda » Wed Feb 07, 2007 11:12 pm

Mark, that is pretty impressive, I'll have to give that a try this week.

Thanks
Bob
Bob Reda
Vectric Wizard
 
Posts: 724
Joined: Wed Aug 16, 2006 7:34 pm
Location: Monessen, Pa
Model of CNC Machine: shopbot 48x48 upgraded prt

Previous

Return to VCarve - General

Who is online

Users browsing this forum: No registered users and 30 guests