Tony / Brian:
Another item that would be nice to have in Vcarve, is the ablility to change the step over for pocketing beyond what you currently have. I was doing a project lately
and I was limited to having a step over LESS than 50%. If I need to pocket out a large area, say perhaps 18" x 24" and I want to use a 1" diameter cutter, I cannot
set the step over beyond 49.9%. If I was able to set the step over to 90% or more, this would save a lot of machining time. It would be nice to be able to set the
step over to what ever amount a person wanted.
Thanks,
Pete
Another wish list item
-
- Vectric Craftsman
- Posts: 196
- Joined: Wed Jun 07, 2006 7:26 pm
- Location: Calgary, Alberta Canada