Does anybody out there have any advice on settings, pressure, toolpaths, etc. for using the CNC pen holder/writer
that I got from Rockcliff a while ago ??
I believe I have some ideas for applications for this gadget, but I could use some start-up procedure advice.
Any help is appreciated ..... John
Pen Writer/holder
- mtylerfl
- Vectric Archimage
- Posts: 5892
- Joined: Thu Jan 29, 2009 3:54 am
- Model of CNC Machine: -CarveWright CNC -ShopBot Buddy PRSAlpha
- Location: Brunswick, GA
Re: Pen Writer/holder
Hi John,
Have you contacted the manufacturer to see if they have any particular setting recommendations?
Have you contacted the manufacturer to see if they have any particular setting recommendations?
Michael Tyler
facebook.com/carvebuddy
-CarveWright CNC
-ShopBot Buddy PRSAlpha CNC
facebook.com/carvebuddy
-CarveWright CNC
-ShopBot Buddy PRSAlpha CNC
Re: Pen Writer/holder
Hi Michael - Only sparce centerline and basic pressure setup ... nothing
on z-axis start height or speeds.
on z-axis start height or speeds.
- mtylerfl
- Vectric Archimage
- Posts: 5892
- Joined: Thu Jan 29, 2009 3:54 am
- Model of CNC Machine: -CarveWright CNC -ShopBot Buddy PRSAlpha
- Location: Brunswick, GA
Re: Pen Writer/holder
Ok. You might just need to do some tests on your own. Keep notes you can refer to in the future, for repeating the “good results”
Start with the “pressure” they recommend. Z-Height doesn’t really matter other than making sure the marker lifts enough not to drag unintended lines across your drawing.
Start with the “pressure” they recommend. Z-Height doesn’t really matter other than making sure the marker lifts enough not to drag unintended lines across your drawing.
Michael Tyler
facebook.com/carvebuddy
-CarveWright CNC
-ShopBot Buddy PRSAlpha CNC
facebook.com/carvebuddy
-CarveWright CNC
-ShopBot Buddy PRSAlpha CNC
- highpockets
- Vectric Wizard
- Posts: 3667
- Joined: Tue Jan 06, 2015 4:04 pm
- Model of CNC Machine: PDJ Pilot Pro
Re: Pen Writer/holder
A while back I built a pen holder and ran a test. Came out pretty good.
I used the engraving toolpath and the diamond drag bit tool parameters. I set the depth/pressure to .06", this isn't all that critical just so long as it won't exceed the travel on the pen.
Hope this helps.
I used the engraving toolpath and the diamond drag bit tool parameters. I set the depth/pressure to .06", this isn't all that critical just so long as it won't exceed the travel on the pen.
Hope this helps.
John
Maker of Chips
Maker of Chips
Re: Pen Writer/holder
Thanks. John ...... I'll give it a shot .....
- mtylerfl
- Vectric Archimage
- Posts: 5892
- Joined: Thu Jan 29, 2009 3:54 am
- Model of CNC Machine: -CarveWright CNC -ShopBot Buddy PRSAlpha
- Location: Brunswick, GA
Re: Pen Writer/holder
Hi John,
Please upload a photo or two of what you draw after you get everything dialed in!
Please upload a photo or two of what you draw after you get everything dialed in!
Michael Tyler
facebook.com/carvebuddy
-CarveWright CNC
-ShopBot Buddy PRSAlpha CNC
facebook.com/carvebuddy
-CarveWright CNC
-ShopBot Buddy PRSAlpha CNC