Vectric Customer

Hi,

i have 2007 a idea, i have forgot , and found my old dxf from Stargate , but many are wrong, and not usable for Cut2D and CNC

it's not yet ready for Cutting, i have today over 12hour invested, and i hope it's look like a little as the "original" Gate...

the Prototyp cutting in wood, when it's ok i mill << ?? it from POM or similar plastic ...for Aquarium...

to be continued .. with picture and my German thread


thx for your notice

here the german Thread : http://www.bbmmp.net/forum_08/viewtopic.php?f=10&t=132

when links are not permitted please kill the link thx...


Richard

Hi,


20 hour later not a 1:1 copy but it looks like a little the Original.


i hope i become my Tools the next Time that i can cutout and engrave the "Aquagate" ....


look at the Picture , i have 2 Glyphes less then the Original, and i have my Logo insert , that i have no Copyright Problem with other Gate holder...

to be continued with the foot for the Gate....

Dimension are 240x240x20mm from the Gate...


Regards from Austria
Richard

BBMMP wrote:...look at the Picture , i have 2 Glyphes less then the Original, and i have my Logo insert , that i have no Copyright Problem with other Gate holder...
Regards from Austria
Richard

Looks good Richard. Can't wait to see the final project.

Hi Richard.
It looks very good so far! After taking a closer look at the image I can see how this would take a long time to prep. I am anxious to see the final part also.

BBMMP wrote:Hi,


20 hour later not a 1:1 copy but it looks like a little the Original.


i hope i become my Tools the next Time that i can cutout and engrave the "Aquagate" ....


look at the Picture , i have 2 Glyphes less then the Original, and i have my Logo insert , that i have no Copyright Problem with other Gate holder...

to be continued with the foot for the Gate....

Dimension are 240x240x20mm from the Gate...


Regards from Austria
Richard

Hi Richard this looks cool, did you finish it? would you care to share the dxf or crv?

Best regards

George