Vectric Customer

Hi All,

Here's a new project using Cut2D to mill aluminium (some lathe work as well) for a Microphone Pop Filter, which will hopefully improve my voice over work (can't do much about the voice itself though ).

Part 1:

https://www.youtube.com/watch?v=8x362oNJv4I

Part 2:

https://www.youtube.com/watch?v=f_Eu5UThtXQ

Part 3:

https://www.youtube.com/watch?v=z1exoY4vH1E

Better than what I use...bent coat hanger into a circle with a nylon stocking stretched and fastened over the void!

Thanks for sharing this project! Gave me some good ideas for other pieces I can make for our audio presentations!

Mike

Thanks Mike and Mike,

Definitely better than coat hanger and stocking