Corian wedding gift

The Gallery is for posting photographs and images of work machined using Cut2D

Corian wedding gift

Postby IBBruin » Sun Apr 29, 2012 5:49 pm

Every young newlywed couple needs a good cutting board. The back side is flat. The good part about a corian board is even after a few years of use, if you run over it with a orbital sander, all the cut marks disappear.
Attachments
tessasboard.jpg
IBBruin
 
Posts: 13
Joined: Wed Apr 25, 2012 10:04 pm
Model of CNC Machine: Homegrown

Re: Corian wedding gift

Postby jimwill2 » Sun Apr 29, 2012 6:25 pm

Nice work!
Jim Williams
"If it was easy anybody could do it!"

http://expressionsofhonor.com
jimwill2
Vectric Wizard
 
Posts: 528
Joined: Tue Aug 31, 2010 1:48 am
Location: Superior, Colorado
Model of CNC Machine: CaMaster Stinger w/recoil, FTC

Re: Corian wedding gift

Postby citrusguy » Mon Apr 30, 2012 12:37 am

It should never be used - only admired and treasured.
John Champlain
citrusguy
 
Posts: 17
Joined: Sun May 03, 2009 9:18 pm

Re: Corian wedding gift

Postby subsea » Tue Jul 31, 2012 3:53 pm

That looks great. I want to cut some corian but am not sure how to setup. what type of tool - feed rate - etc. did you use on your piece?

Bill
subsea
Vectric Craftsman
 
Posts: 135
Joined: Tue Jun 05, 2012 12:45 am
Location: Belpre Ohio
Model of CNC Machine: Zenbot 2448

Re: Corian wedding gift

Postby estrelado » Mon Oct 15, 2012 12:16 pm

Hey. Nice work.

We are going to make a cnc work over corian, can you tell me the tool values you use to this job? On Cut 2D?
The material as 6mm... we are going to use an endmill of 8mm
Any help will be appreciated.

Tks

Rui
From Portugal
estrelado
Vectric Apprentice
 
Posts: 1
Joined: Mon Oct 15, 2012 11:52 am
Model of CNC Machine: pronum

Re: Corian wedding gift

Postby IBBruin » Mon Oct 15, 2012 6:49 pm

That was a while back so it would have been on my old, smaller machine that could not go over 30 IPM. I didn't use a roughing pass. I think I used a 1/16 ball nose with a 10% stepover. There are plenty of people here with more experience with Corian than I have. Maybe they can help.
IBBruin
 
Posts: 13
Joined: Wed Apr 25, 2012 10:04 pm
Model of CNC Machine: Homegrown


Return to Cut2D - Gallery

Who is online

Users browsing this forum: No registered users and 3 guests