Lords Prayer

The Gallery is for posting photographs and images of work machined using Cut2D
Post Reply
User avatar
Xxray
Vectric Wizard
Posts: 2300
Joined: Thu Feb 17, 2011 8:47 am
Model of CNC Machine: CAMaster Stinger 1
Location: MI USA

Lords Prayer

Post by Xxray »

Was inspired to do something on the religious side for the holidays, and came up with this, using a simple free use graphic found on the web. I'll include the .dfx if able, in case others want to give it a go.
Didn't notice until I got it off the table, but the bottom right hand corner didn't quite make it. Its not in the file, I can only assume the piece was not screwed down good enough, or something. Because of the fine detail in the lettering, I only went .009 deep ,,, So there wasn't much margin for error.
About 8x10, carved in .45 plexi with a 90 v bit 200 ipm 10,000 rpm.
Attachments
lp.jpg
Lords_Prayer-001.zip
(2.04 MiB) Downloaded 571 times
Doug

fatmawmaw
Posts: 14
Joined: Thu Feb 16, 2012 11:33 pm
Model of CNC Machine: cnc shark pro

Re: Lords Prayer

Post by fatmawmaw »

thanks looksd goo to me
sue

Post Reply