Was inspired to do something on the religious side for the holidays, and came up with this, using a simple free use graphic found on the web. I'll include the .dfx if able, in case others want to give it a go.
Didn't notice until I got it off the table, but the bottom right hand corner didn't quite make it. Its not in the file, I can only assume the piece was not screwed down good enough, or something. Because of the fine detail in the lettering, I only went .009 deep ,,, So there wasn't much margin for error.
About 8x10, carved in .45 plexi with a 90 v bit 200 ipm 10,000 rpm.
- (2.04 MiB) Downloaded 320 times