Circle ver lines (G2 G3 I/J)?
Posted: Wed Oct 22, 2008 5:38 am
Hi, is there a way I can get C2D to use G2 G3 - I/J for circles & arcs?
All I get it to output is lines.
I've tried exporting different file types & tried a few different post processors too, but no joy.
I use CorelDraw v10.
Thanks!
post edit:
I did use the "Draw circle" tool which works fine, but not the idea for using C2D.
All I get it to output is lines.
I've tried exporting different file types & tried a few different post processors too, but no joy.
I use CorelDraw v10.
Thanks!
post edit:
I did use the "Draw circle" tool which works fine, but not the idea for using C2D.