I have a board that is going to have a chamfered edge.
I would like to know how to get the whole piece cut out.
Do I do a off set and if so what would the offset be.
I used a 0.5 90 degree v bit that was set to a depth of .1875 cutting into a .5 thick wood.
if there is a video on this just point me to it.
Thanks Jeff
Cutting out Chamfered edge
- Mike-S
- Vectric Wizard
- Posts: 1123
- Joined: Mon Jun 13, 2011 6:45 am
- Model of CNC Machine: Joe's Hybrid 4x4 (but 3x3)
- Location: Hayesville, NC
Re: Cutting out Chamfered edge
Use your V-bit to "Profile On" the outline vector, then an end mill to cut "Outside" the vector to full depth.
-
- Vectric Wizard
- Posts: 486
- Joined: Mon Nov 06, 2017 1:57 pm
- Model of CNC Machine: Shapeoko 3D XXL
Re: Cutting out Chamfered edge
Thanks I will try that
Jeff
Jeff