Post general information and questions relating to Cut2D in this Forum.
I want to cut a 1/4" rabbit along one edge of a 10x12 piece of plywood. So I need to know how to put a off set to 1 0f the 10" ends of the plywood so to create a inset for the plywood back. I was able to make the dado for the bottom by creating a rectangle and putting it where I wanted it and then pocketing it out. but the rabbit needs to be in 1/4" from the edge so that it is flush with the outer side.
So an help would be great
- Vectric Craftsman
- Posts: 153
- Joined: Mon Nov 06, 2017 1:57 pm
- Model of CNC Machine: Shapeoko 3D XXL
Return to Cut2D - General
Who is online
Users browsing this forum: No registered users and 4 guests