Quick engrave problem
Posted: Fri Oct 27, 2017 3:22 am
I am using the quick engrave tool using Fill and offsets.
I have noticed that occasionally it will not lift up the tool when moving to a different spot. It will cut across several lines. It appears that after it engraves the middle offset, it does not lift up moving to the next vector.
Any ideas?
I originally tried to use the Fill with crosshatch, but that took to long and was too hard on my machine. The offset fill runs much faster and I like the effect.
I am using a diamond drag bit on acrylic to make a lighted LED sign.
I have noticed that occasionally it will not lift up the tool when moving to a different spot. It will cut across several lines. It appears that after it engraves the middle offset, it does not lift up moving to the next vector.
Any ideas?
I originally tried to use the Fill with crosshatch, but that took to long and was too hard on my machine. The offset fill runs much faster and I like the effect.
I am using a diamond drag bit on acrylic to make a lighted LED sign.