Offset - nube question

Post general information and questions relating to Cut2D in this Forum.
Post Reply
mristau
Posts: 15
Joined: Sun Aug 03, 2014 9:58 pm
Model of CNC Machine: 1100x1100mm Shapeoko
Location: Northern Colorado
Contact:

Offset - nube question

Post by mristau »

Haven't run into this before and wondering where to make adjustment...
My zero is set to bottom left but not cutting in the intended location and 3D view confirms origin is beyond material dimensions. Screenshot:
Attachments
offset.JPG

User avatar
Adrian
Vectric Archimage
Posts: 14543
Joined: Thu Nov 23, 2006 2:19 pm
Model of CNC Machine: ShopBot PRS Alpha 96x48
Location: Surrey, UK

Re: Offset - nube question

Post by Adrian »

Try rotating the view. The start point is generally well above the material so at that angle it gives an optical illusion of being away from the corner of the piece when it actually isn't.

Post Reply