Hello,
I searched the forums for MPCNC (my CNC https://www.vicious1.com/forum/forumz/m ... cnc-mpcnc/)
It uses Marlin FW with Ramps 1.4 (Mega 2560). I didn't see Marlin as one of the Post-Processor options. Has anyone had experience with this board?
I know some folks at vicious1.com mentioned created PP for their own, use but I thought maybe Vectric could support it natively.
Thank you
Hansang
Support for Marlin FW Ramps 1.4
Re: Support for Marlin FW Ramps 1.4
The ones support suggested (Shapeko, XCarve) didn't work. But here's one that work:
https://www.vicious1.com/forum/topic/as ... post-26571
https://www.vicious1.com/forum/topic/as ... post-26571