Support for Marlin FW Ramps 1.4

[hansangb]

Hello,
I searched the forums for MPCNC (my CNC https://www.vicious1.com/forum/forumz/m ... cnc-mpcnc/)

It uses Marlin FW with Ramps 1.4 (Mega 2560). I didn't see Marlin as one of the Post-Processor options. Has anyone had experience with this board?

I know some folks at vicious1.com mentioned created PP for their own, use but I thought maybe Vectric could support it natively.

Thank you

Hansang

[hansangb]

The ones support suggested (Shapeko, XCarve) didn't work. But here's one that work:

https://www.vicious1.com/forum/topic/as ... post-26571