off set and array icons

[mrputz1]

if you have a dxf file placed on the layout . what are the steps using the off set and layout icons to duplicate the part to cut several of them.

[Adrian]

You wouldn't really use the offset for that.

You can either use the nesting tool or array copy tool to create multiple copies.

[mrputz1]

ok i can get to that screen PERHAPS A DUMB ? do i click on array copy what i need is instructions of steps if you will after i get to array copyto add the same file i have placed on the board to make several of the same

[IslaWW]

From the top menu, click on "Help", then "Help Contents"
Scroll down to "The Offset and Layout Tool Group"
Click on them as needed to see documentation for each Icon

[mrputz1]

IslaWW: Thank you i get it Finally . Its difficult to explain on line so thank you very much.