Up Cut or Down Cut Bit
-
- Posts: 17
- Joined: Thu Sep 22, 2011 4:50 am
- Model of CNC Machine: Probotix Asteroid
- Location: Boyertown, PA
Up Cut or Down Cut Bit
Have never done a profile cut. Just been V carving. I am looking to profile cut completly through 1/4", and 3/4" MDF and PVC Sheet. Should I be looking at getting a up or down cutting bit? I would think up because wouldn't down cutting keep jamming the waste material back into the cut area? Or am I completly off and it has to do with finish sides (top/bottom). On that note, should I be getting a spiral cut or straight cut?
- Rcnewcomb
- Vectric Archimage
- Posts: 5930
- Joined: Fri Nov 04, 2005 5:54 am
- Model of CNC Machine: 24x36 GCnC/WinCNC with ATC
- Location: San Jose, California, USA
- Contact:
Re: Up Cut or Down Cut Bit
This thread may help: ->Link
- Randall Newcomb
10 fingers in, 10 fingers out, another good day in the shop
10 fingers in, 10 fingers out, another good day in the shop