Switch to English language?

Post general information and questions relating to Cut2D in this Forum.
Post Reply
Jibeji
Posts: 33
Joined: Fri May 22, 2015 9:58 am
Model of CNC Machine: CNC 3020

Switch to English language?

Post by Jibeji »

Hello,
The question fo the day. :)
Is it possible to switch in English language?
I have installed Cut2D Desktop in French and I regret...
I am a beginner in CNC milling and as most of the documentation available on the internet is written in English, it will be easier for me to transpose.

User avatar
BrianM
Vectric Staff
Posts: 1964
Joined: Mon May 16, 2005 10:15 am
Model of CNC Machine: A few ...
Location: Alcester U.K
Contact:

Re: Switch to English language?

Post by BrianM »

Hi,

If you create a new shortcut to the Cut2DDesktop.exe executable in

C:\Program Files\Cut2D Desktop 8\x64 (assuming 64bit windows and English windows) and run the program from that it will start up in English.

You could also edit the existing shortcut you use to run the program (by right clicking on the shorcut and choosing properties) and remove the "/lang=FRA" part of the 'Target' section.

Brian

Jibeji
Posts: 33
Joined: Fri May 22, 2015 9:58 am
Model of CNC Machine: CNC 3020

Re: Switch to English language?

Post by Jibeji »

Thank you Brian!

Post Reply