I used the x, y coordinate entry boxes to enter various points to create one continuous polygon shape of 10 sides.
So when i click on it, everything is highlighted as one unit.
I would like to split the shape up into its separate lines.
Is this possible?
Thanks
K
Can I split a polygon into its separate lines?
-
- Vectric Craftsman
- Posts: 177
- Joined: Fri Jul 18, 2014 10:26 am
- Model of CNC Machine: ShapeOko 2
- mezalick
- Vectric Wizard
- Posts: 2970
- Joined: Mon Nov 03, 2008 9:07 am
- Model of CNC Machine: Camaster Cobra
- Location: Philadelphia, PA USA
- Contact:
Re: Can I split a polygon into its separate lines?
I believe you could click on the vector, change to Node editing, and cut each node as needed.
It can be done in Aspire so I'm assuming that it can be in Cut2D.
Michael
It can be done in Aspire so I'm assuming that it can be in Cut2D.
Michael
Michael Mezalick
https://www.youtube.com/user/mezalick
mm@mezalick.com
https://www.youtube.com/user/mezalick
mm@mezalick.com
-
- Vectric Craftsman
- Posts: 177
- Joined: Fri Jul 18, 2014 10:26 am
- Model of CNC Machine: ShapeOko 2
- mezalick
- Vectric Wizard
- Posts: 2970
- Joined: Mon Nov 03, 2008 9:07 am
- Model of CNC Machine: Camaster Cobra
- Location: Philadelphia, PA USA
- Contact:
Re: Can I split a polygon into its separate lines?
Yes, Same process..
Michael
Michael
Michael Mezalick
https://www.youtube.com/user/mezalick
mm@mezalick.com
https://www.youtube.com/user/mezalick
mm@mezalick.com