Page 1 of 1
Clock, Pocket cut
Posted: Wed Aug 03, 2011 4:08 pm
by grjensen
Is is possible to do a pocket cut but preserve the height of the numbers. I would like to cut down 1/8 in the surface but leave the numbers untouched. I only have Cut2D. Can this be done with VCarvePro.
Re: Clock, Pocket cut
Posted: Wed Aug 03, 2011 4:14 pm
by Adrian
Select all the vectors and create a pocket toolpath with a 1/8" cut depth. That will take away all the material inside the circle but leave the numbers standing. You'll need a pretty small bit to get round the numbers though.
Re: Clock, Pocket cut
Posted: Wed Aug 03, 2011 4:57 pm
by grjensen
I wasn't selecting all vectors. So simple. works great. thank you