Sorry about taking forever to respond, I am only at my internship so many days out of the week. The version I had was a trial. I wasn't sure because someone had given me the cd saying that it was the full version, but I realized when all of my tool paths ended at 500 lines it must have been a trial. I have since purchased the full version and all of my tool paths are being generated.
Now I am just having a problem setting the Z
I start the program and the spindle goes up too high even though I set the zero about an inch away from the material surface. I think I have to tinker with the offsets.
Thanks for the help though I greatly appreciate it.