first litho
- deadgoodcharlie
- Vectric Apprentice
- Posts: 97
- Joined: Thu Jan 01, 2009 9:47 pm
- Location: Whitby Canad
- glenn
- Vectric Wizard
- Posts: 582
- Joined: Wed Jul 02, 2008 11:23 pm
- Model of CNC Machine: home brew 40x20
- Location: McArthur, Ohio U.S.A.
Re: first litho
deadgoodcharlie,
Very good work!
I must get photovcarve...looks like lots of fun!
Thanks for posting
Very good work!
I must get photovcarve...looks like lots of fun!
Thanks for posting
- deadgoodcharlie
- Vectric Apprentice
- Posts: 97
- Joined: Thu Jan 01, 2009 9:47 pm
- Location: Whitby Canad
- BSImages
- Vectric Wizard
- Posts: 340
- Joined: Fri Jan 20, 2006 7:36 am
- Model of CNC Machine: Home designed and built.
- Location: Pine Grove, California
- Contact:
Re: first litho
Nice, but I think you might now be hooked...
- deadgoodcharlie
- Vectric Apprentice
- Posts: 97
- Joined: Thu Jan 01, 2009 9:47 pm
- Location: Whitby Canad
Re: first litho
Ya I,m hooked alright Well the pictures are not too clear in these next shots.The frame is not 100% finished , just a mock up realy.The stand was from an old Ikea lamp wich worked well because it had a large screw-on type washer.I did post the DXF for the frame sides on the other half of this forum. The bulb is 25 watts so it is not hot at all. Looks better in person, but all in all a lot of fun cheers.
- deadgoodcharlie
- Vectric Apprentice
- Posts: 97
- Joined: Thu Jan 01, 2009 9:47 pm
- Location: Whitby Canad
Re: first litho
Forgot to mention that the material is white plastic lense covering for a light fixture, thickness is .062 and the photo carving was done at .030 deep 70 ipm. This material can be bought at home depote 2x4 for around 11 bucks.