I was going to have James do this logo for me (sorry James).
I had never played much in PhotoVCarve, after a few minutes of reading some of the forum post and 10 minutes in the program... i was ready to cut...
this is my logo... I did stop the machine before it came back on the cross hatch pass. I thought for a first run this was great!
logo carve
- handcrafted
- Posts: 13
- Joined: Thu Nov 15, 2007 9:26 pm
- Location: breslau, ontario, canada
- Contact:
- handcrafted
- Posts: 13
- Joined: Thu Nov 15, 2007 9:26 pm
- Location: breslau, ontario, canada
- Contact: