Just some pics

Gallery for images of work cut using PhotoVCarve
Post Reply
User avatar
deadgoodcharlie
Vectric Apprentice
Posts: 97
Joined: Thu Jan 01, 2009 9:47 pm
Location: Whitby Canad

Just some pics

Post by deadgoodcharlie »

image.jpg
It's been a while since I used photo carve so thought I would post some pics.Thanks for viewing.
Attachments
image.jpg
image.jpg
image.jpg
image.jpg
image.jpg

MTSO
Vectric Craftsman
Posts: 260
Joined: Tue Mar 11, 2014 6:12 pm
Model of CNC Machine: salecnc XJ1224
Location: Auckland New Zealand

Re: Just some pics

Post by MTSO »

Great stuff. How do you eliminate your photo backgrounds?. also what settings are you using.

regards

Brian

GaryR6
Vectric Wizard
Posts: 401
Joined: Sat May 23, 2009 6:28 pm
Location: AZ

Re: Just some pics

Post by GaryR6 »

Nice work, I never seem to get the hang of photo carve...... but you seem to. Nice.

User avatar
deadgoodcharlie
Vectric Apprentice
Posts: 97
Joined: Thu Jan 01, 2009 9:47 pm
Location: Whitby Canad

Re: Just some pics

Post by deadgoodcharlie »

Thanks Brian, I use paint.net it's free its like the old windows paint but much
better. With the Monroe vcarve I used the lasso function around the original picture then cropped it and that got rid of the background. For my corian lithos I pocket the back flip it over and then do my carve, I tell the software I'm using a .030 ballmill when in fact I'm using a small vbit. I use 15% step over cut at 80 ipm in one go. The Beatles litho is done in sign plastic but I actualy did use the .030 ballmill, material is .125 thick and I only went down.061 . At 80 ipm it took 1.40 hours. Most of my knowledge came from this forum , I'm very greatfull.The cartoon sketch was done with my rock cliff pen/marker holder, using cut2d. It was a test on dollar store canvas frames.

User avatar
deadgoodcharlie
Vectric Apprentice
Posts: 97
Joined: Thu Jan 01, 2009 9:47 pm
Location: Whitby Canad

Re: Just some pics

Post by deadgoodcharlie »

GaryR6 wrote:Nice work, I never seem to get the hang of photo carve...... but you seem to. Nice.
Thanks GaryR6 lots info on this forum.

Post Reply