A few more of my PVC's
-
- Vectric Wizard
- Posts: 493
- Joined: Sat Jun 11, 2011 3:27 pm
- Model of CNC Machine: Probotix Meteor 25 x 50
- Location: Jefferson City, Mo.
Re: A few more of my PVC's
Those are great. I haven't tried a PVC in wood, but have done more in corian then I could count. I have been thinking of doing some. Any particulars you'd share ?
-
- Posts: 37
- Joined: Wed Feb 26, 2014 2:07 pm
- Model of CNC Machine: denford microrouter/denford triac
- Location: Snodland, Kent
- Contact:
Re: A few more of my PVC's
Thank you. I always use a 0.1mm step over with a 1Bn, this I have found gives the best amount of detail. Programme run time's can be abit lengthy, the Merc took almost 3 hrs, but thats also because my cnc controller is not that good as the likes of say Mach3, but also dependant on size of pic too.