a somewhat good photocarve

Gallery for images of work cut using PhotoVCarve

a somewhat good photocarve

Postby knight-toolworks » Fri May 18, 2007 5:07 pm

I have been battling getting a decent picture. part of it was the onsrud 60 bit was just not doing a good job of fine lines. I bought one of the simple v carve bits from http://www.centuriontools.com/3fldsr.htm and it sure cut cleaner then the onsrud bit. getting a decent picture is hard too.
this is on some of that white bathroom panels that is hardboard under it. got to use a vacuum to hold it down it does not stay flat.
Image
knight-toolworks
Vectric Apprentice
 
Posts: 58
Joined: Fri Apr 27, 2007 6:05 pm
Location: portland oregon

Re: a somewhat good photocarve

Postby knight-toolworks » Tue May 22, 2007 6:30 am

well this one sucks got a bar better one done. a few little blowouts for some reason.
Image
knight-toolworks
Vectric Apprentice
 
Posts: 58
Joined: Fri Apr 27, 2007 6:05 pm
Location: portland oregon


Return to PhotoVCarve - Gallery

Who is online

Users browsing this forum: No registered users and 2 guests