This doesn't even come close to the Intarsia posted here
I cut this useing an .125 rotozip saber bit from Lowes.
It took almost 2hrs at about 8fpm 12000rpm with a 8% stepover. Does that seem about right for something like this?
I did it in one pass I had to slow the feed rate way down because the bit was flexing to much. I thought it was going to snap and shot into my eyeball I was watching pretty close
Hey Don FYI that is your standerd 1973 American dime
Thanks for looking at my miniscuelle attempt at cut 3d,
Nick
Guess it helps to have a picture. Sorry