St Francis

by **Bob Reda** » Sun Jul 06, 2008 4:36 pm

Here's a model of St Francis I just completed it is 9.5x14.5
Used 1/4"bn for rough and 1/8" for final pass
took 4 1/2 hours

by **gcioffi** » Wed Jul 09, 2008 9:57 pm

very good

is file stl ?

by **Bob Reda** » Thu Jul 10, 2008 11:51 am

yes it is. I got it through the 3dmodel club

by **Lazyman** » Sun Apr 19, 2009 12:53 pm

I realize this was posted a quiet a while a go, but can what kind of wood is that carving made of and what did you finish it with?

by **Bob Reda** » Sun Apr 19, 2009 3:26 pm

The wood is maple and I believe I put on two coats of finish then van dyke brown glaze over top and another coat of finsih.

Bob

by **Lazyman** » Mon Apr 20, 2009 6:41 pm

Thanks!

It looks great!

by **cabnet636** » Thu May 21, 2009 2:03 am

bob that is really nice!!

jim

by **Bruce Dorworth** » Thu Sep 17, 2009 5:16 am

I am interested in cutting one of these. Can the model be purchased some where?

Bruce

by **capnl** » Thu Sep 17, 2009 8:52 am

Bob Reda wrote:yes it is. I got it through the 3dmodel club

by **loobyloo** » Fri Jul 13, 2012 4:02 pm

That's simply amazing.