Loking for a 3D Leprechaun

Post by **Phil** » Tue May 27, 2008 12:25 am

Does anyone know where I can get a Leprechaun image for a 3D carving?

Post by **CLyon** » Mon Jun 02, 2008 7:19 pm

I understand they are very hard to capture....

Post by **DavidCousins** » Mon Jun 02, 2008 7:30 pm

Often reported hanging around the base of rainbows!

Post by **Thkoutsidthebox** » Mon Jun 02, 2008 9:09 pm

Post by **Phil** » Mon Jun 02, 2008 10:15 pm

Well, David the next time you spot one at the end of a rainbow I'd greatly appreciate it if you would take a picture of the little fellow for me.

Post by **DavidCousins** » Mon Jun 02, 2008 10:54 pm

Phil,
Just so happens, Google found us an image.
http://www.fannation.com/blogs/post/166555
Now did you need this in a 3D model?
Dave

Post by **Phil** » Tue Jun 03, 2008 1:59 pm

If we can get him to pull his pants up I think I can use him.

Post by **RoutnAbout** » Tue Jun 03, 2008 2:55 pm

Phil,
This isn't a 3D model, but was the best leprecon I could find.

Post by **3dmodelclub** » Wed Jul 09, 2008 8:31 am

They look quite cute, I will suggest if we make some.

Tom.

www.3dmodelclub.com

Post by **Rcnewcomb** » Wed Jul 09, 2008 5:28 pm

Post by **gpdc** » Sun Jul 13, 2008 8:46 pm

James Booth (jab@carve3d.com) can help you.....worked for me!
GPDC

Vectric Customer